Transponder - Onboard Programming: Yes - must have 2 (different) programmed keys. &nbsp; <h1 class="name post-title entry-title">Remote Programming</h1> <div class="clear"></div> <div class="entry"> FORD REMOTE – THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE. ALL FUNCTIONING REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE There are a couple of different procedures that will program your remotes depending on what year your vehicle is. <strong>Be sure to review all programming steps before proceeding</strong> <strong>Make sure that you don’t press the brake pedal at any time during or before the procedure.</strong> <strong>Procedure A:</strong> 1.Close all doors, then open drivers door and press the Unlock button on driver’s door twice while it is open, insert key into ignition. 2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1) (Off is the position where you can remove your key, RUN is the position just shy of starting your car.) 3.Within 10 seconds press ANY button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5. 4.Within 10 seconds, press ANY button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4. for all other remotes. 5.Turn ignition to OFF. Locks will again cycle to indicate end of programming mode. *If this does not work try the procedure with the door closed. <strong>Procedure B:</strong> 1. Fasten seatbelt and close all doors 2. Turn the ignition from OFF to RUN 4 times within 3 seconds. 3. Turn the ignition OFF. The system will chime to confirm programming mode. 4. Within 10 seconds, press and hold any button on first keyless remote. The system will chime once to confirm programming. 5. Within 10 seconds, press and hold any button on second keyless remote. System will chime once to confirm programming. 6. Turn ignition to RUN to exit programming mode. Please note: All steps should be performed in fairly rapid succession. If you never get the initial chime or door lock cycle, that means the vehicle has never entered programming mode. You should remove key from ignition, open and close the door and start over. </div>