<strong>Be sure to review all programming steps before proceeding</strong> <ol> <li><strong>  Locate the Data Port under drivers side dashboard usually located to the right of steering column.</strong><strong> </strong><strong>SEE GALLERY PHOTO OF OBD PORT</strong><strong>          </strong>    <strong> </strong></li> <li><strong> Insert keys in ignition and leave in the OFF position.</strong></li> <li><strong> Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Port terminals 1 and 4 with a suitable jumper wire, leave the jumper wire connected throughout the programming procedure. Make sure you know which terminals are 1 and 4.</strong></li> <li><strong> Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. Note: The doors will automatically lock and unlock once at this time indicating that the system is in the programming mode. </strong></li> <li><strong> Press the LOCK  button on the remote to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.</strong></li> <li><strong> Repeat step 5 with up to 4 remotes (including any existing remotes) within one minute. After completing each programming, the doors will lock and unlock once.</strong></li> <li><strong>Disconnect the programming wire and remove the keys from the ignition.</strong></li> </ol>