Important Note about the VERSA NOTE. If using T-Code or MVP to program, you will need to select an older version of the versa (like 2009) <strong>Be sure to review all programming steps before proceeding</strong> <strong>Nissan Versa</strong> IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again. <ol> <li>Close and lock all doors with the driver’s side power lock/unlock switch. Insert key into ignition and remove it from the ignition key cylinder at least 6 TO 10 times within 10 seconds.  The Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.</li> <li>Insert key into the ignition cylinder and turn to the ACC position.</li> <li>Within 5 seconds, push ANY button on the remote transmitter. The Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.</li> <li>If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).</li> <li>Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.</li> </ol> <strong>Nissan Rogue</strong> There is no manual way to program remotes to this vehicle. You will need to use the  T-Code, MVP, or Nissan Consult III tool.